Roland R1000 Series Manual page 86

Start-up
This system parameters are only for EtherNet/IP
system parameter:
EthernetIP DHCP:
Fig. 67: Setting DHCP
system parameter: 6b
IP: 192.168.
Fig. 68: Setting IP-Address
system parameter: 6c
Snet: 255.255.255.
Fig. 69: Setting SubNet
system parameter: 6d
GWay: 0.
Fig. 70: Setting Gateway
System parameter 7: Indicating of the the Bus baud rate.
system parameter:
busbaudrate
500kb
Fig. 71: Indicating of the Bus baud rate
Setting the Bus baud rate depends on the Bus type:
Profibus: up to 12Mbps/s; selection at master
DeviceNet: 125/250/500/kBit
CanOpen: 10/20/50/125/250/500/800/1000 kbps
ProfiNet IO: ----
CC-Link: 125/625kbps 2,5/5/10Mbps
EtherNet/IP: – –
EtherCAT: – –
86
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
6
no
0. 10
0
0. 0. 0
7
Manual
When DHCP is switched on, the IP-setting will be
done via DHCP. When DHCP is switched off, the IP-
address, SubNet and Gateway must be selected.
The IP-address can be selected here.
The SubNet can be selected here.
The Gateway can be selected here.
B0063191 / 1.3