Roland R1000 Series Manual page 46

Communication with the PLC
6.3.8 Calibration dynamic (L20-3-XX-S only)
During the dynamic calibration the sheet must be passed between the sensors.
BIN 8.2 / 12.2 / 15.2 / 18.2
Calibration
BIN 11.7 /14.7 / 17.7 / 20.7
Range
BOUT 8.0
1)
Function result
BOUT 8.2
Function fault
OUT 8.3
Ready
Fig. 22: Timing diagram for Teach-In 1-sheet – dynamic
1)
In case of "Function fault" = 1 "Function result" will sometimes remain at 0.
46
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
Calibration
Range
> 0 ms
> 350 ms
Note
The measured timing periods were determined with
12 Mbit-Profibus. These timing periods can vary with different
transmission rates and bus systems. The cycle time of the PLC
has not been taken into account.
Note
The thickness of the calibration sheet is set in menu adjustment
parameter in chapter 7.8
Manual
Range
< 0.5 s
B0063191 / 1.3
< 15 ms