Toyota Tundra 2005 Service - Repair - Maintenance page 3471

AC-106
To "COOL"
To "COOL"
AIR CONDITIONING
2.
(a)
(b)
(c)
HINT:
Lock the clamp while lightly pushing the outer cable in the direc-
To "FACE"
tion shown by the arrow in the illustration.
I28081
(d)
HINT:
Lock the clamp while lightly pulling the outer cable in the direc-
tion shown by the arrow in the illustration.
I11169
(e)
HINT:
Lock the clamp while lightly pulling the outer cable in the direc-
tion, shown by the arrow in the illustration.
I11170
3.
4.
5.
6.
7.
- HEATER CONTROL ASSEMBLY
ADJUST HEATER CONTROL CABLES
Set the mode control dial at the "FACE" position.
Set the temperature control dial at the "MAX. COOL" posi-
tion.
Adjust the mode control cable.
Pull the air inlet control link to the "FACE" position, con-
nect the control cable and lock the clamp.
Adjust the air mix control cable.
Pull the air inlet control link to the "COOL" position, con-
nect the control cable and lock the clamp.
Adjust the water valve control cable.
Pull the air inlet control link to the "COOL" position, con-
nect the control cable and lock the clamp.
INSTALL HEATER TO REGISTER DUCT NO. 4
INSTALL LOWER NO. 2 FINISH PANEL
INSTALL GLOVE COMPARTMENT PANEL
INSTALL HEATER TO REGISTER DUCT NO. 2
INSTALL LOWER LH FINISH PANEL
(See page BO-120 )
Author : Date :
5133