INSTALLATION
_ Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension
diagram. (See the body dimension diagram)
_ Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the
finish.
_ After welding, apply the polyurethane foam to the corresponding parts.
_ After welding, apply body sealer and under-coating to the corresponding parts.
_ After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
POINT
1
Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel rein-
forcement and back window upper frame.
HINT:
1)
Apply just enough sealer for the new parts to make contact.
2
Bend the flange hem with a wooden hammer and dolly.
HINT:
1)
Perform hemming three steps, being careful not to warp the panel.
BODY PANEL REPLACEMENT
BP-39
F16961