Emerson Micro Motion 1000 Series Configuration And Use Manual page 94

Optional Configuration
Table 8-8 Status alarms and severity levels continued
Communicator message
Alarm code ProLink II message
(7)
A108 Event #1 Triggered
Event 1 Triggered
(7)
A109 Event #2 Triggered
Event 2 Triggered
A110
Frequency Output Saturated
Frequency Output Saturated
A111 Frequency Output Fixed
Frequency Output Fixed
(8)
A112 Software Upgrade Recommended
S/W Upgrade Recommended
A113 Secondary mA Output Saturated
Secondary mA Output Saturated
A114 Secondary mA Output Fixed
Secondary mA Output Fixed
A115 External Input Error
External Input Error
A116 API Temperature Out-of-Limits
API: Temperature Outside Standard Range
A117 API Density Out-of-Limits
API: Density Outside Standard Range
A118 Discrete Output 1 Fixed
Discrete Output 1 Fixed
A119 Discrete Output 2 Fixed
Discrete Output 2 Fixed
A120 ED: Unable to fit curve data
ED: Unable to Fit Curve Data
A121 ED: Extrapolation alarm
ED: Extrapolation Alarm
(3)
A131 Meter Verification Info Alarm
Meter Verification/Outputs at Last Value
(4)
A131 Meter Verification in Progress
Meter Verification In Progress
(2)
A132 Simulation Mode Active
Simulation Mode Active
(1) Applies only to systems with the standard core processor.
(2) Applies only to systems with the enhanced core processor.
(3) Applies only to systems with the original version of the meter verification application.
(4) Applies only to systems with Smart Meter Verification.
(5) If outputs are set to Last Measured Value, severity is Info. If outputs are set to Fault, severity is Fault.
(6) Can be set to either Info or Ignore, but cannot be set to Fault.
(7) Applies only to events configured using the single-setpoint event model.
(8) Applies only to systems with transmitter software earlier than rev5.0.
84
Default
severity Configurable
Info Yes
Info Yes
(6)
Info Yes
(6)
Info Yes
Info Yes
(6)
Info Yes
(6)
Info Yes
Info Yes
Info Yes
Info Yes
(6)
Info Yes
(6)
Info Yes
Info No
Info Yes
Info Yes
Info Yes
(6)
Info Yes
Micro Motion Series 1000 and Series 2000 Transmitters
Affected by
fault timeout
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No