Emerson Micro Motion 1000 Series Configuration And Use Manual page 231

Menu Flowcharts – Model 1700/2700 IS Transmitters
Figure F-2 ProLink II configuration menu
Flow
• Flow direction
• Flow damp
• Flow cal
• Mass flow cutoff
• Mass flow units
• Vol flow cutoff
• Vol flow units
• Vol flow type
• Std gas vol flow cutoff
• Std gas flow units
• Std gas density
Gas wizard
• Mass factor
• Dens factor
• Vol factor
• Flow switch variable
• Flow switch setpoint
• Enable entrained air
handling
T Series
• FTG
• FFQ
• DTG
• DFQ1
• DFQ2
• K3
• D3
• D4
• K4
Configuration and Use Manual
ProLink >
Configuration
Additional configuration options
Density Temperature
• Dens units • Temp units
• Dens damping • Temp cal factor
• Slug high limit • Temp damping
• Slug low limit • External temperature
• Slug duration
• Low density cutoff
• K1
• K2
• FD
• D1
• D2
• Temp coeff (DT)
Analog output
Primary/secondary output
• PV/SV is
• Lower range value
• Upper range value
• AO cutoff
• AO added damp
• LSL
• USL
• Min Span
• AO fault action
• AO fault level
• Last measured value timeout
Pressure
• Flow factor
• Dens factor
• Cal pressure
• Pressure units
Frequency/Discrete output
Frequency
• Tertiary variable
• Scaling method
• Freq factor
• Rate factor
• Pulses per unit
• Units per pulse
• Freq pulse width
• Last measured value timeout
• Freq fault action
• Freq output polarity
Discrete output
• DO assignment
• DO polarity
• DO fault action
221