Emerson Micro Motion 1000 Series Configuration And Use Manual page 104

Pressure Compensation, Temperature Compensation, and Polling
Figure 9-5 Configuring polling with ProLink II
Polling for pressure
ProLink >
Configuration >
Polled variable 1
Specify Polling control
Apply
Enter HART tag
of external device
Specify Process variable
Apply
Done
94
Polling for temperature
ProLink >
Configuration >
Temperature
Set External temperature
to 32 °F (0 °C)
Polled variables
Polled variable 2
(1)
Specify Polling control
Enter HART tag
of external device
Specify Process variable
Apply
(1) Choose Primary if the external
(2)
Apply
(2) If you are configuring both Polled
Apply
Done
Micro Motion Series 1000 and Series 2000 Transmitters
device will probably be accessed
by another device acting as a
secondary master (e.g., a
Communicator). Choose
Secondary if the external device
will probably be accessed by
another device acting as a
primary master.
Variable 1 and Polled Variable 2,
use the same Polling Control
setting for both. If you do not, Poll
as Primary will be used for both
devices.