Emerson Micro Motion 1000 Series Configuration And Use Manual page 194

Menu Flowcharts – Model 1500 AN Transmitters
Figure C-3 ProLink II configuration menu continued
Device
• Tag
• Date
• Descriptor
• Message
• Sensor type
• Transmitter serial number
• Floating pt ordering
• Add comm resp delay
Digital comm settings
• Fault setting
• HART address
• Loop current mode
• HART device ID
• Modbus address
• Enable write protection
Update rate
• Update rate
• 100 Hz variable
Burst setup
• Enable burst
• Burst cmd
• Burst var 1...4
Alarm
• Alarm
• Severity
Figure C-4 ProLink II configuration menu continued
Variable mapping
• PV is
• SV is
• TV is
• QV is
184
ProLink >
Configuration
T Series
• FTG
• FFQ
• DTG
• DFQ1
• DFQ2
• K3
• D3
• D4
• K4
Events Discrete events
• Event 1/2 • Event name
• Variable • Event type
• Type • Process variable
• Setpoint • Low setpoint (A)
• High setpoint (B)
ProLink >
Configuration
System
• W & M approval
• Reset options
Additional configuration options
Special Units
• Base mass unit
• Base mass time
• Mass flow conv fact
• Mass flow text
• Mass total text
• Base vol unit
• Base vol time
• Vol flow conv fact
• Vol flow text
• Vol total text
Discrete input
• Assignment
• Polarity
Sensor Transmitter options
• Sensor s/n • Volume flow
• Sensor model • Meter fingerprinting
• Sensor matl • Meter verification
• Liner matl
• Flange
Micro Motion Series 1000 and Series 2000 Transmitters
Sensor simulation
• Enable/disable
Mass flow
• Wave form
• Fixed value
• Period
• Minimum
• Maximum
Density
• Wave form
• Fixed value
• Period
• Minimum
• Maximum
Temperature
• Wave form
• Fixed value
• Period
• Minimum
• Maximum
Polled variables
Polled variable 1/2
• Polling control
• External tag
• Variable type
• Current value