Display Switch; Shift Button - Sony Digital Betacam DVW-700 Operation Manual

5 HOLD (display hold) button
Pressing this button instantly freezes the time data displayed in the
counter display section. (The time code generator continues normal
2
operation.) Pressing this button again releases the hold. One use of this
feature is to determine the exact time of a particular shot.
See Section 2-8 "Warnings and Indications on the Display Panel" (page 2-37) for
more information about the counter display.
6 RESET (counter reset) button
This button resets the time data displayed on the counter display section
to "00 : 00 : 00 : 00" and the user bit data to "00000000".

7 DISPLAY switch

Depending on the settings of the F-RUN / R-RUN switch and the REAL
TIME switch, this switch selects data to display in the counter display
section, as follows:
CTL : CTL
TC : Time code
U-BIT : User bits
For more information, see "Time code displays" (page 2-39).
8 ADVANCE button
For setting the time code or user bits, each press of this button
increments the flashing digit selected by the SHIFT button.

9 SHIFT button

For setting the time code or user bits, this button selects the digit to be
changed. The selected digit flashes.
!º PRESET / REGEN (regeneration) switch
This switch determines whether the time code for a recording is made
continuous from the previous recording on the tape, or starts afresh.
2-32
Chapter 2 Locations and Functions of Parts and Controls