Sony Digital Betacam DVW-700 Operation Manual page 35

!∞ AUTO W / B BAL (automatic white / black balance adjustment)
switch
This switch activates the adjustment functions of the white balance and
2
black balance.
WHT : Automatic adjustment of the white balance. If the WHITE BAL
switch is set to A or B, the white balance setting is stored in the
corresponding memory.
BLK : Selects either of the following two functions.
• Automatic adjustment of the black set and the black balance. The
setting is stored in a separate memory.
• If this switch is held at BLK until the black balance adjustment ends,
black shading is automatically adjusted next.
!§ SHUTTER selector
Set this selector to ON to use the electronic shutter. Set it to SEL to
switch the shutter speed or mode setting within the range that has been
previously set from the setup menu.
Note that if the display mode is set to 2 or 3 when this selector is adjusted,
the new setting will be indicated on the setting change / adjustment
progress message display area of the viewfinder screen for about 3
seconds (e.g. :SS : 1/250 or :ECS : 45.2 Hz).
For more information about the shutter speed and mode settings, see Section 4-2
"Setting the Electronic Shutter" (page 4-12).
!¶ REMOTE (remote control) connector (6-pin)
Connect the RM-P9 Remote Control Unit (not supplied) to this connector.
Notes
• When the RM-P9 Remote Control Unit is connected, the setup menu is
displayed on the monitor, regardless of the internal board setting.
• The control function cannot be used for both the REMOTE and TEST
OUT connectors at the same time when signals are being generated at
both connectors. If these connectors are used at the same time, it may
not be possible to generate signals at standard levels.
2-22
Chapter 2 Locations and Functions of Parts and Controls