Sony Digital Betacam DVW-700 Operation Manual page 199

Notes on RM-P9 operation
The functions and use of some switches and controls on the RM-P9
depend on the camera that is connected. In the RM-P9 Operation and
Maintenance Manual those switches and controls are explained
separately for each camera.
For operation of the RM-P9 connected to one of the DVW-700 series,
refer to the explanations for the BVP-90 / 90P as well as the notes below.
• All the control knobs, switches, and indicators of the RM-P9 are
operable.
• Set the MODE switch to 1.
• The A / B / MANUAL selector, WHITE BALANCE RED / BLUE
control knobs, BLACK BALANCE RED / BLUE control knobs, and
the SHUTTER selector operate the same way as in the BVP-90 / 90P.
• The setup menu operates from the RM-P9 side (although some of the
pages and functions may not be valid).
Viewing the menu: Connect a monitor to the MONITOR connector of
the RM-P9 or the TEST OUT connector of the camcorder.
Canceling the settings / resetting to the initial settings: It is possible
to use the spare switch on the RM-P9 to cancel a setting
(CANCEL) or reset it to its initial value (PRESET). Press the
switch to the bottom position to cancel and the top position to reset
to the initial value.
When the RM-P9 is connected to the camcorder, the automatic white
balance and R/B GAIN painting data set with the RM-P9 are saved in a
special memory within the camcorder. When the RM-P9 is
disconnected, these settings revert to the values last set on the
camcorder. If you set the SW2-4 switch on the RM-P9 to ON, the data
set with the RM-P9 in the camcorder's memory are maintained as long
as the camcorder is turned on.
Chapter 5 Setting Up the Camcorder
5
5-43