Testing The Vtr - Sony Digital Betacam DVW-700 Operation Manual

6-1-3 Testing the VTR

Perform tests (1) to (6) consecutively in the given order.
(1) Testing the tape transport functions
1
Set the VTR SAVE / STBY switch to SAVE and check that the
VTR SAVE indicator in the viewfinder goes on.
2
Set the VTR SAVE / STBY switch to STBY and check that the
VTR SAVE indicator in the viewfinder goes off.
3
Set the F-RUN / R-RUN switch to R-RUN.
4
Set the DISPLAY switch to CTL.
6
5
Press the VTR START button and check the following points.
• The tape reels are turning.
• The counter indication is changing.
• The REC indicator in the viewfinder is on.
• The RF and SERVO indicators on the display panel are off.
6
Press the VTR START button again, and check that the tape stops
and that the REC indicator in the viewfinder goes off.
7
Repeat the checks of steps 5 and 6, this time using the VTR button
on the lens.
8
Press the RESET button, and check that the counter display goes to
"00 : 00 : 00 : 00".
9
Turn on the LIGHT switch, and check that the display panel is
illuminated.
6-6
Chapter 6 Maintenance