Mode Selector - Siemens SIMOTION C230-2 Equipment Manual

Device Data
Display of LEDs
The following LEDs are on the front panel of the C230-2. The LEDs and their func-
tion are described in Table 3-2.
Table 3-2
SF (red)
5 VDC (green)
RUN (green) -
C230-2 in RUN
STOPU (yellow) –
C230-2 in STOP User
Program
STOP (yellow) –
C230-2 in STOP
BUS1F (red) –
group fault
BUS2F (red) –
group fault
Q0...Q7, I0...I11,
B1...B4, M1, M2 (green) –
digital inputs/outputs
Control elements

Mode selector

Certain operating modes can be selected using the mode selector (see Subsec-
tion 3.1.1).
3-22
Status and fault displays
LED
This LED indicates a fault on the C230-2.
(See Section 3.3)
This LED indicates that the power supply for the electronics is
ready.
(See Section 3.3)
This LED indicates that the user program is running.
(See Section 3.3)
This LED indicates that the technology packages (e.g.
synchronous operation, cam) are active. The user program is
not active.
(See Section 3.3)
This LED indicates that no user program is running. The
technology packages are not active.
(See Section 3.3)
This LED indicates a fault on the C230-2's PROFIBUS DP1
interface (X8).
(See Section 3.3)
This LED indicates a fault on the C230-2's PROFIBUS DP2
/MPI interface (X9).
(See Section 3.3)
These LEDs show the status of the digital inputs/outputs.
(See Subsection 3.1.8)
Function
E Siemens AG, 2003 All rights reserved
SIMOTION C230-2, 04.2003 Edition