Wiring - Siemens SIMOTION C230-2 Equipment Manual

Wiring

Basic rules
As a C230-2 can be used for a wide range of applications, we can only list the ba-
sic rules for the electrical configuration in this chapter. You must, as a minimum,
comply with these basic rules to ensure problem-free operation.
Safety regulations
In order to ensure that your system operates safely, adopt the following measures
and adapt them to suit your conditions:
S An EMERGENCY STOP strategy in accordance with the generally accepted
rules of current engineering practice (e.g. European Standards EN 60204,
EN 418 and similar).
S Additional measures to limit the end position of axes (e.g. hardware limit
switches).
S Equipment and measures to protect motors and power electronics in accor-
dance with the SIMODRIVE installation guidelines.
In addition, in order to identify hazards, we recommend that a risk analysis for the
entire system be made in accordance with the basic safety requirements set out in
Appendix 1 of EU Machinery Directive 89/392/EEC.
Other references
Please also note the information in the following sections of this manual:
S Guidelines on Handling Electrostatically Sensitive Devices (ESD),
Appendix C.
S You can find further information on the design of a system with the S7-300 pro-
cess I/O in the Manual S7-300 Programmable Controller, Hardware and Instal-
lation, CPU Data, Section on "Wiring".
For further information on EMC guidelines we recommend the publication: EMC
Installation Guidelines, project design instructions (HW),
Order no.: 6FC5 297-0AD30-0AP1.
Standards and specifications
When wiring the C230-2, you must observe the applicable VDE guidelines, espe-
cially VDE 0100 or VDE 0113 for shutdown devices, short-circuit and overload
protection.
E Siemens AG, 2003 All rights reserved
SIMOTION C230-2, 04.2003 Edition
6
6-79