Assign The Mounting Location - Bosch DDU 7 Manual

150 en | Enhancements
19.1.2

Assign the mounting location

The mounting location is used for determination between the different M 60.
Following position definitions are possible: Front, Rear, Center, Gearbox, Front Left, Front
Right, Rear Left, Rear Right
At delivery no mounting location is set. This is signaled by an orange 'RUN' led on the device.
Therefore one must first assign a mounting location to the M 60 before it can be used in the
project. The mounting location is permanently saved in the M 60. If necessary you can at any
time reassign a different mounting location following the same procedure.
A mounting location must not be used several times in one network, this would disturb the
functionality of the respective M 60.
1.
04.02.2019 | V 02 |
In the Project Tree right click on the project name e.g. 'New Project' and then select
'Show discovered devices...'
All connected M 60 are listed.
Manual
Display Unit DDU 7
Bosch Motorsport