Shindaiwa DGK70F Service Manual page 31

Bolt
0.2 in.
Nut
Nut
29
11) Fit the stator and the engine housing.
12) Temporarily fasten the 2 bolts (M10 x
55) on a diagonal line until the bearing
come toward the engine cover.
13) Fasten the 2 bolts (M10 x 55) until the
gap between the stator and engine
cover would be approx. 0.2 in. (or 0.5
cm)
14) Unfaten the 2 bolts (M10 x 55) after the
gap reached to 0.2 in. (or 0.5 cm)
15) Retighten the bolts (M10 x 55) with
the nut (M12) to tighten further.
16) Temporarily tighten the 8 bolts (M10 x
55) on a diagonal line.
17) Remove 2 each of the bolts (M10 x
55) and nuts (M12) that tighten in
above 14).
18) Torque the 2 bolts (M10 x 55) with a
torque wrench that removed in above
16). Torque to the required value
below.
19) Torque the 8 bolts (M10 x 55) with a
torque wrench on the diagonal line
that tighten in above 15). Torque to
the required value below.
[Fastening Torque]
49.0～56.0 N･m (500～571 kgf･cm)
20) Torque the 2 nuts (M10) by a torque
wrench. Torque to the required
value.
[Fastening Torque]
44.2～53.9 N･m (451～549 kgf･cm)