HP ProCurve 9304M Security Manual page 108

Security Guide for ProCurve 9300/9400 Series Routing Switches
Table 4.3: Output from the show dot1x statistics command (Continued)
This Field...
RX EAP Resp/Id
RX EAP Resp other than Resp/Id
RX EAP Length Error
Last EAPOL Version
Last EAPOL Source
TX EAPOL Total
TX EAP Req/Id
TX EAP Req other than Req/Id
Clearing 802.1X Statistics
You can clear the 802.1X statistics counters on all interfaces at once, on individual interfaces, or on a range of
interfaces.
For example, to clear the 802.1X statistics counters on all interfaces on the device, enter the following command:
ProCurveRS# clear dot1x statistics all
Syntax: clear dot1x statistics all
To clear the 802.1X statistics counters on interface e 3/11, enter the following command:
ProCurveRS# clear dot1x statistics e 3/11
Syntax: clear dot1x statistics <portnum>
Displaying Dynamically Assigned VLAN Information
The show interface command displays the VLAN to which an 802.1X-enabled port has been dynamically
assigned, as well as the port from which it was moved (that is, the port's default VLAN).
4 - 22
Displays...
The number of EAP-Response/Identity frames received on the port
The total number of EAPOL-Response frames received on the port
that were not EAP-Response/Identity frames.
The number of EAPOL frames received on the port that have an
invalid packet body length.
The version number of the last EAPOL frame received on the port.
The source MAC address in the last EAPOL frame received on the
port.
The total number of EAPOL frames transmitted on the port.
The number of EAP-Request/Identity frames transmitted on the port.
The number of EAP-Request frames transmitted on the port that were
not EAP-Request/Identity frames.
June 2005