HP ProCurve 9304M Security Manual page 105

Table 4.1: Output from the show dot1x command (Continued)
This Field...
re-authentication
quiet-period
tx-period
supp-timeout
server-timeout
max-req
re-authperiod
security-hold-time
Protocol Version
June 2005
Displays...
Whether periodic re-authentication is enabled on the device. See
"Configuring Periodic Re-Authentication" on page 4-12.
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
When the HP device is unable to authenticate a Client, the amount of
time the HP device waits before trying again (default 60 seconds).
See "Setting the Quiet Period" on page 4-12 for information on how to
change this setting.
When a Client does not send back an EAP-response/identity frame,
the amount of time the HP device waits before retransmitting the EAP-
request/identity frame to a Client (default 30 seconds).
See "Setting the Interval for Retransmission of EAP-Request/Identity
Frames" on page 4-12 for information on how to change this setting.
When a Client does not respond to an EAP-request frame, the amount
of time before the HP device retransmits the frame.
See "Specifying a Timeout for Retransmission of EAP-Request
Frames to the Client" on page 4-14 for information on how to change
this setting.
When the Authentication Server does not respond to a message sent
from the Client, the amount of time before the HP device retransmits
the message.
See "Specifying a Timeout for Retransmission of Messages to the
Authentication Server" on page 4-13 for information on how to change
this setting.
The number of times the HP device retransmits an EAP-request/
identity frame if it does not receive an EAP-response/identity frame
from a Client (default 2 times).
See "Specifying the Number of EAP-Request/Identity Frame
Retransmissions" on page 4-13 for information on how to change this
setting.
How often the device automatically re-authenticates Clients when
periodic re-authentication is enabled (default 3,600 seconds).
See "Configuring Periodic Re-Authentication" on page 4-12 for
information on how to change this setting.
The amount of time the device disables an interface when it detects
multiple Clients trying to connect on the interface, when the multiple -
hosts command is not present in the interface's configuration.
See "Specifying the Security Hold Time" on page 4-13 for information
on how to change this setting.
The version of the 802.1X protocol in use on the device.
Configuring 802.1X Port Security
4 - 19