HP ProCurve 9304M Security Manual page 107

Table 4.2: Output from the show dot1x config command for an interface (Continued)
This Field...
OperControlledDirections
AuthControlledPortControl
AuthControlledPortStatus
multiple-hosts
Displaying 802.1X Statistics
To display 802.1X statistics for an individual port, enter a command such as the following:
ProCurveRS# show dot1x statistics e 3/3
Port 3/3 Statistics:
RX EAPOL Start:
RX EAPOL Logoff:
RX EAPOL Invalid:
RX EAPOL Total:
RX EAP Resp/Id:
RX EAP Resp other than Resp/Id:
RX EAP Length Error:
Last EAPOL Version:
Last EAPOL Source:
TX EAPOL Total:
TX EAP Req/Id:
TX EAP Req other than Req/Id:
Syntax: show dot1x statistics <portnum>
The following table describes the information displayed by the show dot1x statistics command for an interface.
This Field...
RX EAPOL Start
RX EAPOL Logoff
RX EAPOL Invalid
RX EAPOL Total
June 2005
Displays...
The setting for the OperControlledDirections parameter, as defined in
the 802.1X standard. According to the 802.1X standard, if the
AdminControlledDirections parameter is set to BOTH, the
OperControlledDirections parameter is unconditionally set to BOTH.
Since the AdminControlledDirections parameter on HP devices is
always set to BOTH, the OperControlledDirections parameter is also
set to BOTH.
The port control type configured for the interface. If set to auto,
authentication is activated on the 802.1X-enabled interface.
The current status of the interface's controlled port: either authorized
or unauthorized.
Whether the port is configured to allow multiple Supplicants accessing
the interface on the HP device through a hub.
See "Allowing Access to Multiple Hosts" on page 4-14 for information
on how to change this setting.
0
0
0
0
0
0
0
0
0007.9550.0B83
217
163
0
Table 4.3: Output from the show dot1x statistics command
Displays...
The number of EAPOL-Start frames received on the port.
The number of EAPOL-Logoff frames received on the port.
The number of invalid EAPOL frames received on the port.
The total number of EAPOL frames received on the port.
Configuring 802.1X Port Security
4 - 21