System Administration Log - Nortel Enterprise Edge 2.0 Programming Manual

3. Select Yes to continue. If new items have been added since the log items were
displayed, these new items are not erased.

System administration log

The System administration log keeps a record of administrative events such as
sessions in which a change was made, invalid password attempts, and password
changes. You can check the items in the log, check when each item in the log
occurred and you can erase the log.
Note: The System administration log holds a maximum of ten items. Erase the log
after dealing with all the items.
Use the System admin log selection under Diagnostics, MSC to perform one of
the following procedures.
• Display information on the items in the System Administration log
• Erase the log
Display information on the items in the System Administration log
You can display information on any item in the System administration log using the
following procedure.
1. Choose Diagnostics, MSC, System admin log.
2. Double click on the System admin log heading to display all the items in the
log. If there are no log entries, the navigation tree indicates that there are no
subheadings.
3. Click an item.
Information about the log item appears. The description attribute indicates if
the item is an event or alarm and includes the associated code. The severity,
repeats, time and parameters of the event or alarm appears. For more
information on the event or alarm, refer to
messages on page 285.
Note: Alarms also appear in the Windows NT event log.
4. Write down the item on the System administration log record and repeat these
steps until you record all the items.
Erase the log
You can erase log items from the System Administration log using the following
procedure.
Note: You cannot remove selected log items. You only have the option of removing
all the log items.
P0911588 Issue 01
on page 283
Enterprise Edge 2.0 Programming Operations Guide
Maintenance 283
Alarm codes on page 285 or
on page 283
Event