Mib Ii Information - Nortel Enterprise Edge 2.0 Programming Manual

274 Maintenance
14.17.40 Command failed. Error in setting action
for input/output filters
14.17.41
Reason: You were attempting to set the
action for input/output filters on the
interface. The operation failed because,
there were no input or output filters
defined for the interface.
14.17.68 Command failed. Error is setting static
route. This problem is caused by a
mismatch in destination network address
in its subnet mask specified in the route.
The routing protocol is changed and the
screen didn't update.
The routing protocol for the interface
shows up as 'RIP'. But no RIP
configuration parameters show up on the
screen
14.5.77 Invalid Data Value. Static default route is
not permitted in this version. Reason:
You were setting a static route that was a
default route for the system. In this
release of Enterprise Edge, setting
default routes as static routes is not
permitted. The default route is managed
by the 'Net Link Manager' component
that accepts the address of next hop
router on the primary and then adds or
deletes (manages) the default route in the
system.

MIB II Information

Here is the mapping between Enterprise Edge counters shown in statistics windows
and standard MIB-II variables where applicable.
This section includes:
• Counters Shown at LAN and WAN Interface Levels
• Counters Shown at LAN and WAN Interface Levels
• ICMP Counters
• UDP Counters
• TCP Counters
• QoS Session Counters
• QoS Best Effort Traffic Counters
• QoS Dropped Packets Counters
• QoS Graph Counters
Enterprise Edge 2.0 Programming Operations Guide
Add an input or output filter before
setting the action
Match them. Bitwise 'AND' of
destination address and subnet mask
should be equal to the destination
address.
Refresh the screen by clicking on 'View
Refresh' menu item.
Set the routing protocol back to 'NONE'
and then set to 'RIP' again. The RIP
configuration field would show up.
None
P0911588 Issue 01