Programming The Pri Routing Table - Nortel Enterprise Edge 2.0 Programming Manual

130 Configuring Enterprise Edge Services
DN type
The DN type setting shows only for service type Tie.
6. Select Public or Private DN type.
Call by Call Service routing
The following is an example of a Routing Table containing Call by Call
programming (available in the North America market profile).
Route #
(000-999)
003
004
005
006
007
008
Note: The public DN lengths are used for all PRI calls except those whose routes use service type
Private or service type Tie with DN Type specified as Private.
The service identifier (SID) depends on the selected service type (for example, with
NI-2 protocol).
Service Type
Public
FX
Tie
OUTWATS
a
Private
Switched Digital
a. For NI-2, do not program the Carrier Access Code for banded OUTWAT calls. This call may
be rejected.
When you select or change a PRI protocol, the Service Type and Service ID fields
automatically clear for each entry in the routing table for that PRI.

Programming the PRI routing table

The dialing plan must be thoroughly planned out in advance before programming
the information into the Enterprise Edge system.
To program the routing table:
1. Choose Services, Telephony Services, Call Routing, Routes.
1. Under Route001, External #:, type a number (up to 24 digits).
Enterprise Edge 2.0 Programming Operations Guide
Dial Out Use Pool
(24 digits)
PRI-A
PRI-A
PRI-A
PRI-B
PRI-B
PRI-B
Service Identifier description
None
Facility Number 1-5 digits
Facility Number 1-5 digits
Optional Band Number 1-3 digits
None
None
Service Type Service
Identifier
Public
FX xxxxx
Tie xxxxx
OUTWATS xxx
Private
Switched Digital
P0911588 Issue 01