Dn Lengths - Nortel Enterprise Edge 2.0 Programming Manual

162 Configuring Enterprise Edge Services
Remote package
6. Click a Remote package value: None or Package:. If you select Package:,
type the 2-digit remote package and press Enter. See
on page 160 for more information.

DN lengths

The DN lengths setting allows you to change the number of digits for the Received
number length and the DN length.
To assign DN lengths:
1. Choose Services, Telephony Services, General settings, DN lengths.
The DN lengths window appears.
Received # length
The Received number length setting allows you to change the number of digits
received on auto-answer trunks. These digits identify target lines, Auto DNs, and
DISA DNs.
2. In the Received # length box, select the setting: 2, 3, 4, 5, 6, or 7.
DN length
The DN length setting allows you to change the number of digits for all DNs. The
maximum length is seven. The default and minimum length is 3.
3. In the DN length box, select the setting: 3, 4, 5, 6, or 7.
4. Press the Tab key to save the new DN length.
The prompt appears, "If Nortel Networks Voice Message is installed all
messages and mailboxes will be deleted.".
Enterprise Edge 2.0 Programming Operations Guide
Tips
The target line number (for example, line 241) and the Received number for
the target line (for example, Received number: 123 for line 241) are two
different numbers.
The Received number length may be the same as the system DN length, or
may, because of network or central office constraints, be set to some other
value.
Changing the Received number length causes all programmed received digits
to be cleared.
Remote access packages
P0911588 Issue 01