Setting Up Your Enterprise Edge System; Enterprise Edge Required Parameters - Nortel Enterprise Edge 2.0 Programming Manual

Setting up your Enterprise Edge system

Refer to the following information when setting up your Enterprise Edge system.
•

Enterprise Edge required parameters

• Setting up an Enterprise Edge IP Address
• Setting up web-based administration
• Logging on to Enterprise Edge
• Logging off Enterprise Edge
• Rebooting the Enterprise Edge server
• Shutting down Enterprise Edge System
• Licensing on page 41
• Configuring system settings
• System registration
Enterprise Edge required parameters
The Enterprise Edge quick start module provides quick access to the parameters
necessary for the Enterprise Edge server to become active online. However, you
must enter a minimum set of parameters within the quick start module. For more
information, see the Enterprise Edge Installation and Maintenance Guide.
Obtain the required parameter values from an Internet Service Provider (ISP) or
corporate network administrator.
Note: Configure all the required parameters during the initial configuration
session after you power on the Enterprise Edge server and connect with
either an RS-232 or an Ethernet port. After you configure the parameters,
reboot the Enterprise Edge server from either the console or Unified
Manager.
Enterprise Edge required parameters are:
• Initial IP address and mask for each network interface
• Primary (and optional secondary) DNS servers
• Default next-hop router
• Fractional T1 channel numbers (if you are using fractional TI)
• System name
• WAN link protocol
• Frame Relay DLCI / CIR (if applicable)
P0911588 Issue 01
on page 35
on page 36
on page 37
on page 37
on page 40
on page 40
on page 40
on page 41
on page 42
Enterprise Edge 2.0 Programming Operations Guide
3