Ricoh Pro 907 Operating Instructions And Troubleshooting page 45

Problem
Paper is fed out halfway
through the printing, so that a
single-page print job is
printed across multiple
pages, or an error report is
printed.
A print instruction was issued
from the computer, but
printing did not start.
Cause
The data transfer from the
computer to the printer may
be taking time.
User Authentication may
have been set.
Other Printing Problems
Solution
If you are using this printer as a PCL
printer, under [General Settings], [Basic
Configuration], [Printer Features], set
[Wait Timeout (Non-PS)] to "0" or a time
longer than that currently specified.
If you are using this printer as a
PostScript printer, under [Basic
Configuration], [Printer Features], set the
following two settings to "0" or a time
longer than that currently specified:
• [Wait Timeout (Non-PS)] in
[General Settings]
• [Wait Timeout (PS)] in [PS / PDF
Menu]
If you specify "0" for the above settings
to, the printer will continue to wait for
data sent from the computer. If an
unexpected problem occurs with the
computer or network, it might be
necessary to switch the printer's main
power off and then back on to cancel
data reception.
If you have specified values other than
"0" in the above settings, set the [Wait
Timeout (Non-PS)] setting to a longer
time than the [Wait Timeout (PS)] setting.
For details about this function, see "Basic
Configuration", Printer Reference
Ask your administrator about the user
code. To print, you must enter the user
code through the printer driver. In the
[Job Options] menu in the printing
preferences properties dialog box,
enter the user code in [Login user name:]
in [User Authentication]. For details, see
"Using User Authentication", Printer
Reference .
2
.
43