Ricoh Pro 907 Operating Instructions And Troubleshooting page 28

2. Troubleshooting When Using the Printer Function
Message
"Load following paper in
Interposer Lower Tray"
2
"Load following paper in
Interposer Upper Tray."
"Load xx size paper."
(A figure is placed at xx.)
"Make sure that the paper
tray is not overloaded and the
paper is set correctly."
"Multi-sheet fold is not
available with the selected
fold type. Press [Job Reset] to
cancel printing."
"No response from the server.
Authentication has failed."
26
Cause
The Interposer Lower Tray is
empty.
The Interposer Upper Tray is
empty.
The size of the paper in the
paper tray was changed
while printing was
suspended.
The paper tray is overloaded,
or the paper is not set
correctly.
Multi-sheet fold was specified
with a fold type that cannot be
used when multi-sheet
folding.
Authentication under LDAP
and server authentication has
failed. The same names with
different IDs are registered on
another server, and the
account names are
overlapping due to the
domain server being
switched or some similar
event.
Solution
Load the relevant tray, or press [Job
Reset] to cancel the print job. See "If
Paper Size and Type Errors Occur",
Printer Reference . For details about
loading paper, see "Loading Paper",
About This Machine
Load the relevant tray, or press [Job
Reset] to cancel the print job. See "If
Paper Size and Type Errors Occur",
Printer Reference . For details about
loading paper, see "Loading Paper",
About This Machine
Load paper of the specified size.
Load paper only as high as the upper
limit markings of the paper tray, or load
paper correctly. See "Loading Paper",
About This Machine
Press [Job Reset] to cancel the print job,
and then check the printer driver settings.
For details about this function, see
"Fold", Printer Reference
"Appendix", About This Machine
Contact the administrator.
.
.
.
, or
.