Related Commands
enable (4-26)
authentication enable (4-93)
IP Filter Commands
Command
management
show management Displays the switch to be monitored or
management
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. Use the no
form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Table 4-11 IP Filter Commands
Function
Configures IP addresses that are allowed
management access
configured from a browser
S
M
YSTEM
ANAGEMENT
C
OMMANDS
Mode Page
GC
4-37
PE
4-38
4-37