Table of Contents
Advertisement
Command Groups
The system commands can be broken down into the functional groups
shown below
Command Group
Line
General
System Management Controls system logs, system passwords, user
Flash/File
Authentication
Access Control List
SNMP
Interface
Mirror Port
Rate Limiting
Link Aggregation
.
Table 4-4 Command Group Index
Description
Sets communication parameters for the serial port
and Telnet, including baud rate and console
time-out
Basic commands for entering privileged access
mode, restarting the system, or quitting the CLI
name, browser management options, and a variety
of other system information
Manages code image or switch configuration files
Configures logon access using local or remote
authentication; also configures port security and
IEEE 802.1X port access control
Provides filtering for IP frames (based on address,
protocol, TCP/UDP port number or TCP control
code) or non-IP frames (based on MAC address or
Ethernet type)
Activates authentication failure traps; configures
community access strings, and trap managers; also
configures IP address filtering
Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
Mirrors data to another port for analysis without
affecting the data passing through or the
performance of the monitored port
Controls the maximum rate for traffic transmitted
or received on a port
Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control
Protocol for port trunks
C
G
OMMAND
ROUPS
Page
4-13
4-25
4-31
4-84
4-91
4-114
4-146
4-173
4-188
4-190
4-192
4-11
Advertisement
Table of Contents
