Table of Contents
Advertisement
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5
Information of Eth 1/5
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
1000full
Broadcast storm:
Broadcast storm limit:
Flow control:
LACP:
Port security:
Max MAC count:
Port security action:
media type:
Current status:
Link status:
Operation speed-duplex: 1000full
Flow control type:
Console#
Configuring Interface Connections
You can use the Port Configuration or Trunk Configuration page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex mode, and flow
control.
Command Attributes
•
Name – Allows you to label an interface. (Range: 1-64 characters)
•
Admin – Allows you to manually disable an interface. You can disable
an interface due to abnormal behavior (e.g., excessive collisions), and
then reenable it after the problem has been resolved. You may also
disable an interface for security reasons.
•
Speed/Duplex – Allows you to manually set the port speed and
duplex mode (i.e., with auto-negotiation disabled).
•
Flow Control – Allows automatic or manual selection of flow control.
1000T
00-30-F1-DF-9C-A5
Up
Auto
10half, 10full, 100half, 100full,
Enabled
500 packets/second
Disabled
Disabled
Disabled
0
None
None
Down
None
P
C
ORT
ONFIGURATION
4-183
3-105
Advertisement
Table of Contents
