Table of Contents
Advertisement
• https-certificate - Keyword that allows you to copy the HTTPS
secure site certificate.
• public-key - Keyword that allows you to copy a SSH key from a
TFTP server. (See "Secure Shell Commands" on page 4-44.)
• unit - Keyword that allows you to copy to/from a specific unit in
the stack.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The system prompts for data required to complete the copy
command.
• The destination file name should not contain slashes (\ or /), the
leading letter of the file name should not be a period (.), and the
maximum length for file names on the TFTP server is 127 characters
or 31 characters for files on the switch. (Valid characters: A-Z, a-z, 0-9,
".", "-", "_")
• Due to the size limit of the flash memory, the switch supports only
two operation code files.
• The maximum number of user-defined configuration files depends on
available memory.
• You can use "Factory_Default_Config.cfg" as the source to copy
from the factory default configuration file, but you cannot use it as the
destination.
• To replace the startup configuration, you must use startup-config as
the destination.
• The Boot ROM and Loader cannot be uploaded or downloaded from
the TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.
• For information on specifying an https-certificate, see "Replacing the
Default Secure-site Certificate" on page 3-66. For information on
configuring the switch to use HTTPS/SSL for a secure connection,
see "ip http server" on page 4-40.
F
/F
C
LASH
ILE
OMMANDS
4-85
Advertisement
Table of Contents
