C
L
OMMAND
INE
Related Commands
enable (4-27)
authentication enable (4-93)
IP Filter Commands
Command
management
show
management
management
This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the no form to restore
the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
4-38
I
NTERFACE
Table 4-11 IP Filter Commands
Function
Configures IP addresses that are allowed
management access
Displays the switch to be monitored or configured
from a browser
Mode Page
GC
4-38
PE
4-39