Table of Contents
Advertisement
•
Source/Destination Subnet Mask – Subnet mask for source or
destination address. (See the description for SubMask on page 3-89.)
•
Service Type – Packet priority settings based on the following criteria:
- Precedence – IP precedence level. (Range: 0-8)
- TOS – Type of Service level. (Range: 0-16)
- DSCP – DSCP priority level. (Range: 0-64)
•
Protocol – Specifies the protocol type to match as TCP, UDP or
Others, where others indicates a specific protocol number (0-255).
(Options: TCP, UDP, Others; Default: TCP)
•
Source/Destination Port – Source/destination port number for the
specified protocol type. (Range: 0-65535)
•
Source/Destination Port Bit mask – Decimal number representing
the port bits to match. (Range: 0-65535)
•
Control Code – Decimal number (representing a bit string) that
specifies flag bits in byte 14 of the TCP header. (Range: 0-63)
•
Control Code Bit Mask – Decimal number representing the code bits
to match. The control bitmask is a decimal number (for an equivalent
binary bit mask) that is applied to the control code. Enter a decimal
number, where the equivalent binary bit "1" means to match a bit and
"0" means to ignore a bit. The following bits may be specified:
-
1 (fin) – Finish
-
2 (syn) – Synchronize
-
4 (rst) – Reset
-
8 (psh) – Push
-
16 (ack) – Acknowledgement
-
32 (urg) – Urgent pointer
For example, use the code value and mask below to catch packets with
the following flags set:
-
SYN flag valid, use control-code 2, control bitmask 2
-
Both SYN and ACK valid, use control-code 18, control bitmask
18
-
SYN valid and ACK invalid, use control-code 2, control bitmask
18
A
C
CCESS
ONTROL
L
ISTS
3-91
Advertisement
Table of Contents
