Table of Contents
Advertisement
Command
access-list ip
mask-precedence
mask
show access-list ip
mask-precedence
ip access-group
show ip
access-group
map access-list ip
show map
access-list ip
match access-list ip Changes the 802.1p priority, IP
show marking
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the
source IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Table 4-34 IP ACL Commands (Continued)
Function
Changes to the IP Mask mode used to
configure access control masks
Sets a precedence mask for the ACL
rules
Shows the ingress or egress rule masks
for IP ACLs
Adds a port to an IP ACL
Shows port assignments for IP ACLs
Sets the CoS value and corresponding
output queue for packets matching an
ACL rule
Shows CoS value mapped to an access
list for an interface
Precedence, or DSCP Priority of a
frame matching the defined rule (i.e.,
also called packet marking)
Displays the current configuration for
packet marking
A
C
CCESS
ONTROL
L
C
IST
OMMANDS
Mode
Page
GC
4-123
IP-Mask
4-124
PE
4-127
IC
4-128
PE
4-128
IC
4-129
PE
4-130
IC
4-131
PE
4-132
4-117
Advertisement
Table of Contents
