Sbas Receiver Setting - JRC JMA-5312-6/6HS Installation Manual

4.21

SBAS RECEIVER SETTING

Set to a JRC's SBAS receiver.
SBAS receiver use the information from satellite same as that of beacon which DGPS use. So the accuracy of
position is higher than GPS.
This setting is enabled when a JRC's DGPS is connected to the GPS connector of processor unit.
[I] SBAS mode setting (Mode)
Select the satellite or the beacon whose differential information is used.
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the Mode menu.
2. Select the satellite or the beacon whose differential information is used.
3. Press the [6] key to send the setting value to SBAS receiver.
[Ⅱ] Ranging satellite setting (Ranging)
Set the SBAS satellite to be used or not to be used.
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the SBAS Setting menu.
2. Press [2] key to select the SBAS satellite to be used or not to be used.
3. Press the [6] key to send the setting value to SBAS receiver.
4. NAV equipment Setting
→ 4. GPS Setting
→ 3. SBAS Setting
Beacon : SBAS receiver use the information from beacon
SBAS : SBAS receiver use the information from SBAS satellite
AUTO : SBAS receiver selects automatically
4. NAV equipment Setting
→ 4. GPS Setting
→ 3. SBAS Setting
On : SBAS satellite is used
Off : SBAS satellite is not used
4-
26
→ 1. Mode
4