Installation Of The Lcd Monitor - JRC JMA-5312-6/6HS Installation Manual

3.2

INSTALLATION OF THE LCD MONITOR

1) Installation of the LCD monitor

Install the LCD monitor by taking into consideration the following:
<1> Install the LCD monitor in a convenient location so that when the user is facing the bow the user can
observe the LCD panel to find the target direction.
<2> Select locations where there is least vibration.
<3> It is necessary to allow space for a bend in the installation cable at the rear of the equipment.
2) Connecting the LCD monitor to the radar process unit
The LCD monitor and the radar process unit are connected with three cables. (One cable for the RGB
signal, one cable for power supply and one cable for fan alarm signal.)
Those cables and the LCD monitor are integrated.
<1> Connect the D-sub15 PIN cable, extending from the LCD monitor (NWZ-173), to the connector for
which "VIDEO" is engraved at the rear of the radar process unit cabinet. Turn the control attached
to the connector until it cannot be turned any further.
<2> Connect the 3 PIN cable, extending from the LCD monitor, to the connector for which "VIDEO DC
OUT" is engraved at the rear of the radar process unit cabinet. Turn the plug attached to the
connector until it cannot be turned any further.
<3> Connect the 14 PIN cable, extending from the LCD monitor, to the connector for which "AUX" is
engraved at the rear of the radar process unit cabinet. Turn the plug attached to the connector until
it cannot be turned any further.
3-2
3