JRC JMA-5312-6/6HS Installation Manual page 40

2) Procedure for not using a dedicated cable
When receiving bearing information data from the GPS compass, remove the radar process unit cabinet
cover, and connect the signal line to the terminals located on the terminal board as shown in the following
table:
Signal name
Compass data input +
Compass data input -
Compass data output +
Compass data output -
GND
When the above terminal is used, select the "CMPS" for the heading sensor and set the output of JLR-10 to
NMEA0183.
JLR-10 data output settings must be changed.
For details, refer to JLR-10 instruction manual.
The above-mentioned connections are available only for receiving bearing data from JLR-10. About how
to receive position information, refer to section 3.6.
GPS compass connector side
Disconnected
Disconnected
RADAR-4
RADAR-3
Disconnected
3-11
JMA-5300MK2 side
Disconnected
Disconnected
TB4303 COMPAS+
TB4303 COMPAS-
Disconnected