Tni Blank Setting (Tni Blank) - JRC JMA-5312-6/6HS Installation Manual

[II] Sector Blank Area Creation (Make Sectors 1, 2, and 3)
Procedures 1. Transmit the radar.
2. Open the Serviceman Menu.
3. Perform the following menu open procedure to open the Sector Blank
4. Press numeric keys corresponding to the desired sector creation
5. Set the starting bearing of the sector blank by operating the [EBL] dial,
6. Set the ending azimuth of the sector blank by operating the [EBL] dial,
4.11

TNI BLANK SETTING (TNI BLANK)

Set a sector and stop tuning operation in the bearing.
If a structure such as the mast is close to the radar antenna, automatic tuning operation may become unstable. In this
case, set a TNI blank in the direction of the structure in order to stabilize the tuning operation.
Only one TNI blank sector can be created. The TNI blank function operates in the relative bearing with the bow as
the benchmark.
[I] TNI Blank Function On/Off (Sector)
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the TNI Blank
3. Select the item
setting menu.
2. Installation Menu
→ 3. Sector Blank
Make Sector N .
The selected sector blank will be made.
and press the [ENT] key.
and press the [ENT] key.
setting menu.
2. Installation Menu
→ 9. Next
→ 2. TNI Blank
1. TNI Blank
blank function.
On : The TNI blank function is operated.
Off : The TNI blank function is stopped.
in the menu, and turn on or off the TNI
4-13