JRC JMA-5312-6/6HS Installation Manual page 75

3) Sensor Priority Setting (Sensor Priority)
The system can receive data from 2 sensors. If the same sentences are received from 2 sensors, the
system use primary system's data.
5) Press and hold [RADAR MENU] key.
The Code Input menu will appear.
6) Press the [0] key, and put the cursor on the
The Serviceman Menu will appear.
7) Open the Sensor Priority Setting menu by performing the following menu operation.
2. Installation Menu
8) Select sensors for 1.primary and 2.Secondary .
Default
1. Primary
2. Secondary
Available sensors
No.1 ECDIS No.1 FFD
No.2 ECDIS No.2 FFD
No.3 ECDIS No.3 FFD
No.4 ECDIS No.4 FFD
No.1 MFD No.1 Chart RADAR
No.2 MFD No.2 Chart RADAR
No.3 MFD No.3 Chart RADAR
No.4 MFD No.4 Chart RADAR
4) Synchronization Setting (Synchronization)
Day/Night mode and operation panel brilliance can be synchronized.
1) Press and hold [RADAR MENU] key.
The Code Input menu will appear.
2) Press the [0] key, and put the cursor on the
The Serviceman Menu will appear.
3) Open the Synchronization Setting menu by performing the following menu operation.
2. Installation Menu
4) Set the item Day/Night and Keyboard which are synchronized.
On
Off
→ 9. Next
→ 4. Network
→ 3. Sensor Priority
: No.1 ECDIS
: No.2 ECDIS
Conning Display
No.1 Converter Unit
No.2 Converter Unit
No.1 Alart I/F
No.2 Alart I/F
Port Conning
STAB Conning
No.1 Data Server
i : if you selected "None", the system does not receive data.
→ 9. Next
→ 4. Network
→ 4. Synchronization
: Day/Night and operation panel brilliance are synchronized.
: Day/Night and operation panel brilliance are not synchronized.
3-46
ENT button, and press the [ENT] key.
No.2 Data Server
Console Conning
NAV W/S
No.1 GPS
No.2 GPS
No.3 GPS
No.1 Remote GPS
No.2 Remote GPS
ENT button, and press the [ENT] key.
3
No.3 Remote GPS
ⅰ
None