Installation Of The Operation Unit - JRC JMA-5312-6/6HS Installation Manual

3.3
INSTALLATION OF THE OPERATION
UNIT

1) Installation of the operation unit

The operation unit can be installed at any place as far as it is located within 5 meters from the radar process
unit.
2) Connecting the operation unit to the radar process unit
The operation unit is connected to the radar process unit with one cable. The cable is integrated into the
operation unit. Connect the cable extending from the operation unit to the connector for which "KEY
BOARD" is engraved at the rear of the radar process unit cabinet. Turn the plug attached to the connector
until it cannot be turned any further.
F2
POWER
E
J1
F3
SCANNER
GPS KEY BOARD
J2
J3
To the operation unit
GYRO VIDEO
COMPASS DC OUT
J5 J6
J4
3-3
AUX
VIDEO NMEA
J7 J8