DURKOPP ADLER 867 Durkopp Adler page 36

34
14. Lift the rear tightening lever (12) with the left needle thread.
15. Pull the left needle thread under the rear spring tip (8).
16. Guide the left needle thread under the hook (7).
17. Thread the left needle thread from the bottom through the
needle thread regulator (14).
18. Thread the left needle thread from the right through the upper
hole on the thread lever (15).
19. Insert the right and the left needle thread through the upper
thread guide (9).
The two needle threads must not cross over one another.
For machines with a short thread cutter
20. Insert the left needle thread through the left guide holes above
the thread clamp.
21. Insert the right needle thread through the right guide holes
above the thread clamp.
22. Insert the left needle thread through the left guide holes of the
thread clamp (10).
23. Insert the right needle thread through the right guide holes of
the thread clamp (10).
24. Insert the left needle thread through the left guide holes below
the thread clamp.
25. Insert the right needle thread through the right guide holes
below the thread clamp.
Insert the needle threads into the thread clamp from the left /
right so that the two needle threads are held in place inside
the respective hook of the clamp (see figure Page 30).
26. Insert the right needle thread through the right thread guide
of the needle bar.
27. Insert the left needle thread through the left thread guide of
the needle bar.
Operating Instructions 867 - 04.0 - 03/2018
Operation