DURKOPP ADLER 867 Durkopp Adler page 146

144
Error/
Code Possible cause
warning
2101 Error DA stepper card 1
reference run timeout
2103 Error DA stepper card 1 step
losses
2155 Error DA stepper card 1
overload
2201 Error DA stepper card 2
reference run timeout
2203 Error DA stepper card 2 step
losses
2255 Error DA stepper card 2
overload
3100 Error AC-RDY timeout,
intermediate circuit
voltage did not reach the
defined threshold in the
specified time
3101 Error High voltage fault, mains
voltage > 290 V for an
extended period
3102 Error Low voltage failure
(2
voltage < 150 V AC
3104 Warning Pedal is not in position 0 • When switching the
nd
threshold), mains
Operating Instructions 867 - 04.0 - 03/2018
Troubleshooting
Remedial action
• Check reference
sensor
• Check for stiff
movement
• Check for stiff
movement
• Check reference
sensor
• Check for stiff
movement
• Check for stiff
movement
• Check the mains
voltage
• If the mains voltage is
OK, replace the control
• Check mains voltage, if
nominal voltage is
continuously exceeded
• stabilize it or use a
generator
• Check the mains
voltage
• Stabilize the mains
voltage
• Use generator
control on, take your
foot off the pedal