Qdc Port; Quality Of Service (Qos) - Siemens HIPATH 8000 HIPATH 8000 Administrator's Manual

Alphabetical Reference

QDC Port

Enter port address of the Quality Data Collection Server. For more informa-
tion refer to HiPath QoS Data Collection V1.0 Interface Description.

Quality of Service (QoS)

The QoS technology based on layer 2 and the two QoS technologies Diff-
serv and TOS/IP Precedence based on layer 3 are allowing the VoIP appli-
cation to request and receive predictable service levels in terms of:
•
•
•
Please note that all these technologies are just marking packets which al-
low the network to classify and prioritize the packets accordingly. This
means that the network decides which QoS configuration (marking) will be
used and should be set in the endpoints. The default values are well known
recommendations.
Layer 2 / 802.1p
QoS on layer 2 is using 3 Bits in the 802.1q/p 4-Byte VLAN Tag which has
to be added in the Ethernet header..
The CoS (class of service) value can be set from 0 to 7 . The value 7 is de-
scribing the highest priority and is reserved for network management. Val-
ue 5 is used for voice (RTP-streams) by default. Value 3 is used for signaling
by default.
Layer 3 / Diffserv
Diffserv is classifying traffic flows, like voice (RTP-streams) or signaling
messages into 2 per-Hop-Behavior groups:
1. Expedited Forwarded (EF referred to RFC 2598)
Expedited forwarded is used for voice (RTP-streams) by default.
•
•
•
2. Assured Forwarding (AF referred to RFC 2597)
208
page 142
data through put capacity (bandwidth)
latency variations (jitter)
and delay.
PREAM. SFD DA
High priority traffic to be handeled at the arrival rate
DSCP value: 1 0 1 1 1 0 (DSCP = Diffserv Codepoint)
Effectively creates a special low-latency path in the network
TAG
SA PT
4 Bytes
Three Bits Used for CoS
(User Priority)
DATA FCS