Initial Digit Timer; Intrusion Allowed; Invalid In-/Outbound Packets; Ip Routing - Siemens HIPATH 8000 HIPATH 8000 Administrator's Manual

Initial Digit Timer

This timer determines the delay after which the phone goes back to idle
mode or calls a specified number (if "Warm line" is active) when the hand-
set was lifted or the speaker key was pressed and no number was dialled.
page 64

Intrusion allowed

Allow that an alerting or ringing line is shown in an intrusion bar on DSM
call view. Mark the Checkbox to enable the feature.
Y User Manual

Invalid in-/outbound packets

• Displays the number of error messages according to
• The used MIB objects are:
MIB-Objects
iflnErrors
ifOutErrors
page 93

IP routing

• To have constant access to network subscribers of other domains, you
can enter a total of two more network destinations.
• An IP address of the domain and gateway, and a
must be entered for each further domain you wish to use.
• Use this function to define the following IP addresses for Route 1/2.
IP address
IP address
Gateway
Mask
• Value range table:
Permitted values
Length max.
• Editing by phone: IP Number Editor
page 57
page 116
page 128
Explanation
Non-valid ingoing packets
Non-valid outgoing packets
page 121
Use
IP addess of the selected route
IP address of the gateway for this route
Network mask for this route.
numeric
15 digits (incl. dots)
page 114
Alphabetical Reference
MIB.
Subnet Mask
page 159.
191