Operations; Listening To A Program Source - Sherwood RD-7502 Operating Instructions Manual

Operations

Notes:
• Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup procedures. (For
details, refer to "System Setup" on page 34)

LISTENING TO A PROGRAM SOURCE

Before operation
• Enter the standby mode.
• The POWER ON/STANDBY button lights up .
This means that the receiver is not
disconnected from the AC mains and a small
amount of current is retained to support the
operation readiness.
• To switch the power off, push the POWER
switch again.
• Then the power is cut off and the POWER ON
/ STANDBY button goes off.
1.
In the standby mode, turn the power on.
POWER ON
• Each time the POWER ON/STANDBY button on the
front panel is pressed, the receiver is turned on to enter
the operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR button is
pressed, the receiver is turned on automatically and the
desired input is selected.
2.
Switch the speakers on.
• Then the SPEAKER indicator lights up and the sound
can be heard from the speakers connected to the
speaker terminals.
• When using the headphone for private listening, press
the SPEAKER button again to switch the speakers off.
STANDBY
POWER ON STANDBY
SLEEP
2 3
1
DIMMER
5 6
4
8 9
7
MUTE
VOLUME
P .SCAN
0
D/A MODE CH.LEVEL
DISPLAY SETUP
ENTER
SEL SEL
3.
Select the desired input source.
• Each time the "VIDEO" button on the front panel is
pressed, the input source changes as follows:
→ VIDEO 1 → VIDEO 2 → VIDEO 3
• Each time the "AUDIO" button on the front panel is
pressed, the input source changes as follows:
→ CD → AUX → TAPE
• Each time the BAND button is pressed, the band
changes as follows;
→ FM ST → FM MONO → AM → XM
When selecting the EXTERNAL IN as desired,
• Depending on the surround back speaker setting, "EXT
IN" is displayed and 8(/7/6) separate analog signals
from the component connected to this input pass
through the tone and volume circuits only and can be
heard from your speakers.
• Press the EXTERNAL IN button or select the desired
input source to cancel the external in function.
• These analog signals can be heard only, not
recorded.
15
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
TAPE VIDEO 1 VIDEO 2 VIDEO 3
SOUND
EXT.IN
TONE PARAMETER
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
FM/AM/XM CD AUX
REMOTE CONTROL RC-110
SEL ENTER SEL
EXT.IN
SOUND
TONE PARAMETER EXT.IN
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
REMOTE CONTROL RC-110