Sherwood RD-7502 Operating Instructions Manual page 23

Continued
When selecting the "WIDE" (Dolby Virtual Speaker Wide) mode
2 SP : When using 2 front speakers only.
3 SP : When using 2 front and center speakers
4 SP : When using 2 front and 2 surround speakers.
5 SP : When using 2 front, center and 2 surround speakers.
Note: When the speakers are set to "N" (None), the corresponding speaker layouts cannot be selected.
[Dolby Headphone Parameters]
When selecting the "DH 1", "DH 2", "DH 3" (Dolby Headphone 1,2,3) mode
MOVIE : This provides the surround effect suitable for movie sources.
MSC 1 : This provides the surround effect suitable for music sources.
MSC 2 : This provides less surround effect compared to Music 1 mode.
Note : You can select the listening mode only when playing analog stereo, PCM 2 channel or Dolby Digital 2 channel source.
4.
Repeat the above steps 2 and 3 to adjust other parameters
Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the SPEAKER button is set to off or it is in the stereo mode, etc., the test tone function does not work.
1.
Enter the test tone mode.
D/A MODE
DISPLAY
SEL
PARAMETER
TONE
TAPE VIDEO 1
FM/AM/XM
REMOTE CONTROL RC-110
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
→ FL → C → FR
Front Left Center Front Right
SW ← SL ( ← SB) or ( ← BL ← BR) ←
Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right
• When the speaker setting is "N" (None or No), the test
tone of the corresponding channel is not available.
• ( ) : Possible depending on whether the surround back
channel is set to "2c" (2ch) or "1c" (1ch).
CH.LEVEL
SETUP
ENTER SEL
SOUND
EXT.IN
VIDEO 2 VIDEO 3
CD AUX
→ SR
Surround Right
2.
At each channel, adjust the level as desired until the
sound level of each speaker is heard to be equally loud.
• You can select the desired channel with pressing the
CONTROL UP(▲)/DOWN(▼) buttons or the CURSOR
UP(▲)/DOWN(▼) buttons.
3.
Cancel the test tone function.
23
4
8 9
7
MUTE
P .SCAN VOLUME
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
SOUND
EXT.IN
TONE PARAMETER
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
DISPLAY SETUP
SEL ENTER SEL
SOUND
EXT.IN
TONE PARAMETER
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
REMOTE CONTROL RC-110