Sherwood RD-7502 Operating Instructions Manual page 25

Memorizing the adjusted channel levels
• You can memorize the adjusted channel levels into preset memory("REF 1", "REF 2") and recall the memorized whenever you
want.
1.
After performing the steps 1~4 in "Adjusting the current
channel level" procedure on page 24, press the
(MEMORY/) ENTER button.
7
P .SCAN
DISPLAY
MEMO/ENTER
SEL
TONE
TAPE
FM/AM/XM
• The "1" of "REF 1" indication flickers for several
seconds.
Recalling the memorized channel levels
1.
Press the CHANNEL LEVEL button.
POWER ON
CH. LEVEL
P .SCAN
DISPLAY
SEL
• "CAL" (or "REF 1", etc.) is displayed for several
seconds.
• If the channel level mode display disappears, press this
button again.
8 9
MUTE
VOLUME
0
D/A MODE CH.LEVEL
SETUP
ENTER SEL
ENTER
SOUND
PARAMETER EXT.IN
VIDEO 1 VIDEO 2 VIDEO 3
CD AUX
STANDBY
SLEEP
2 3
1
DIMMER
5 6
4
CH.LEVEL
8 9
7
MUTE
VOLUME
0
D/A MODE CH.LEVEL
SETUP
ENTER SEL
2.
Select the desired one of REF 1 and REF 2.
• If the preset memory disappears, perform the
above step 1 again.
3.
Confirm your selection.
MEMO/ENTER
• The adjusted channel levels have now been memorized
into the selected memory.
2.
Select the desired one of REF 1 and REF 2.
• Then the channel levels memorized into the selected
preset memory are recalled.
25
8 9
7
MUTE
VOLUME
P .SCAN
0
D/A MODE CH.LEVEL
DISPLAY SETUP
ENTER
SEL SEL
SOUND
TONE PARAMETER EXT.IN
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
7
MUTE
P .SCAN VOLUME
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
ENTER
SOUND
TONE PARAMETER EXT.IN
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
8 9
7
MUTE
P .SCAN VOLUME
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
SOUND
TONE PARAMETER EXT.IN
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX