Operations; Listening To A Program Source - Sherwood R-774 Operating Instructions Manual

R-774(A)_ENG_091204:R-774(A) 2009-12-21 오후 2:21 페이지 30

Operations

■Notes:
• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 17 for details
about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu setting
procedures. (For details, refer to "OSD Menu Settings" on page 49.)

LISTENING TO A PROGRAM SOURCE

Before operation
• Enter the standby mode.
• The STANDBY indicator lights up. This
means that the receiver is not disconnected
from the AC mains and a small amount of
current is retained to support the operation
readiness.
• To switch the power off, push the POWER
switch again.
Then the power is cut off and the
STANDBY indicator goes off.
1.
In the standby mode, turn the power on.
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode (the STANDBY indicator goes off) or off
to enter the standby mode(the STANDBY indicator lights
up).
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
2.
Switch the speakers on.
• Then the SPEAKER indicator lights up
and the sound can be heard from the
speakers connected to the speaker
terminals.
• When using the headphones for private
listening, press the SPEAKER button
again to switch the speakers off.
All manuals and user guides at all-guides.com
30
3.
Select the desired input source.
• Each time the INPUT SELECTOR knob on the front
panel is rotated, the input source changes as follows:
→TUNER ↔ CD ↔ TAPE ↔ F.AUX ↔ VIDEO 1 ←
(Frequency display)
→ BT ↔ VIDEO 3 ↔ V2/IPOD ←
• Each time the BAND button (or the TUNER button on
the remote control) is pressed, the band changes as
follows:
→ FM ST → FM MONO → AM → SIRIUS
■
When selecting the ExTERNAL IN as desired,
• Depending on the power amplifier setting for the
surround back channels and the surround back speaker
setting, "EXT. IN" is displayed and 8(/7/6) separate
analog signals from the component connected to this
input pass through the volume circuits only and can be
heard from your speakers.
• Select the desired input source to cancel the external in
function.
• These analog signals can be heard only, not recorded.