Operations; Listening To A Program Source - Sherwood R-904 Operating Instructions Manual

R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 18

Operations

■Notes:
• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 12 for details
about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup procedures.
(For details, refer to "System Setup" on page 33.)

LISTENING TO A PROGRAm SOURCE

Before operation
• Enter the standby mode.
• The POWER ON/STANDBY indicator lights
up amber. This means that the receiver is
not disconnected from the AC mains and a
small amount of current is retained to
support the operation readiness.
• To switch the power off, push the POWER
switch again.
Then the power is cut off and the POWER
ON/STANDBY indicator goes off.
1.
In the standby mode, turn the power on.
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode (the POWER ON/STANDBY indicator
lights up blue) or off to enter the standby mode (the
POWER ON/STANDBY indicator lights up amber).
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
2.
Switch the speakers on.
• Then "SPK ON" is displayed for several
seconds and the sound can be heard from
the speakers connected to the speaker
terminals.
• When using the headphones for private
listening, press the SPEAKER button
again to switch the speakers off. Then
"SPK OFF" is displayed for several
seconds ("H" indicator lights up.)
3.
Select the desired input source.
• Each time the "VIDEO" on the front panel is pressed, the
input source changes as follows:
→ VIDEO 1 → V2/IPOD
• Each time the "AUDIO" button is pressed, the input
source changes as follows:
→ TUNER → CD → AUX → F.AUX
(Frequency display)
• Each time the "TUNER" button on the remote control is
pressed, the band changes as follows:
→ FM ST → FM MONO
18