Sherwood RD-7502 Operating Instructions Manual page 52

Continued
When selecting the DOLBY HEADPHONE
• You can select the desired listening mode for each Dolby Headphone mode.
Note: The listening mode setting is valid only when playing analog stereo, PCM 2 channel or Dolby Digital 2 channel source
in a Dolby Headphone mode.
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the "DOLBY HP", then press the ENTER button.
8 9
7
MUTE
VOLUME
P .SCAN
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
SOUND
EXT.IN
TONE PARAMETER
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired Dolby Headphone mode.
8 9
7
MUTE
P .SCAN VOLUME
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
SOUND
EXT.IN
TONE PARAMETER
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to select the desired listening mode.
7
MUTE
VOLUME
P .SCAN
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
SOUND
EXT.IN
TONE PARAMETER
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
4.
Repeat the above steps 2 and 3 to select the desired listening modes for other Dolby Headphone modes.
ENTER
• Each time the CURSOR UP(▲) / DOWN(▼) buttons are pressed,
"DH 1" (Dolby Headphone 1), "DH 2" or "DH 3" is selected.
MOVIE : This provides the surround effect suitable for movie
sources.
MSC 1 (MUSIC 1) : This provides the surround effect suitable for
MSC 2 (MUSIC 2) : This provides less surround effect compared
52
music sources.
to MUSIC 1 mode.