Setting The Input - Sherwood RD-7502 Operating Instructions Manual

SETTING THE INPUT

INPUT
• D.IN (DIGITAL IN) : To assign the connected DIGITAL INs to the desired input.
• V.MODE (VIDEO MODE) : To output the video input signal to be output from the MONITOR OUTs other than the HDMI MONITOR OUT.
• AUTO (AUTO SURROUND) : To select the auto surround mode or the manual surround mode.
• REMST (REMASTER) : To process the input digital signal and to convert its digital sampling frequency to 88.2/96 kHz for a more
• SYNC (AV SYNC) : To adjust the time delay of audio signals to synchronize the sound with the picture.
• RETURN : To return to the previous menu.
Digital input default settings (*)
"OPT 1" (OPTICAL IN 1) : VIDEO 1, "OPT 2" : "VIDEO 2", "COX 1" (COAXIAL IN 1) : CD, "COX 2" : AUX
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired input source, then press the ENTER button.
7
MUTE
VOLUME
P .SCAN
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL
SOUND
TONE PARAMETER EXT.IN
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired item.
8 9
7
MUTE
VOLUME
P .SCAN
0
D/A MODE CH.LEVEL
DISPLAY SETUP
ENTER
SEL SEL
SOUND
TONE PARAMETER EXT.IN
TAPE VIDEO 1 VIDEO 2 VIDEO 3
FM/AM/XM CD AUX
■Note :
• Depending on the input source, some items other than
"AUTO" (AUTO SURROUND) cannot be selected.
When selecting the DIGITAL IN
• You should assign the connected DIGITAL INs to the desired of CD, AUX and VIDEO 1 ~ VIDEO 2.
(For details, refer to "CONNECTING DIGITAL INS and OUT" on page 8.)
• You can select the desired of OPT 1 (optical 1), OPT 2 (optical 2), COX 1 (coaxial 1), COX 2 (coaxial 2) and ANL (analog).
■Note :
• In such a case that a DIGITAL IN is assigned to two input sources or more, when these input sources are selected, the digital
audio signals can be heard from the same DIGITAL IN.
VID 1 CFG
VID 2 CFG
VID 3 CFG
CD CFG
TAPE CFG
AUX CFG
TUNE CFG
RETURN
detailed sound reproduction.
ENTER
D. IN : OPT 1 / OPT 2 / COX 1 / COX 2 / ANL
V. MODE : AT / CPS / SVD / CPN
AUTO : OFF / ON
REMST : OFF / ON
SYNC : 0 / 0~200
RETURN
Example: When selecting the VIDEO 1
3.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
set the selected item as desired.
7
P .SCAN
DISPLAY
SEL
TONE
TAPE
FM/AM/XM
39
MUTE
VOLUME
0
D/A MODE CH.LEVEL
SETUP
ENTER
SEL
SOUND
PARAMETER EXT.IN
VIDEO 1 VIDEO 2 VIDEO 3
CD AUX